If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Files and Settings Transfer Wizard...
I recently purchased a new Dell PC and used the Files and Settings Transfer
Wizard to transfer everything from my old Dell PC. On the old system, everything went fine and I placed the transfer files within a share on my new PC. I deleted all the files on my old PC. I then went to the new PC and started the Wizard again to import my old stuff. I got an error message that states that the Files and Settings were created with a previous version, and that I should retry using an updated version of the wizard. I already deleted everything from the old PC! My question is this: Have I really lost all those files and settings from the old PC? Or is there a way I can install the older version of the Wizard on the new PC? |
Ads |
#2
|
|||
|
|||
Files and Settings Transfer Wizard...
If you haven't erased the old computer then run the F.A.S.T. wizard on it
and create a floppy disk with the wizard on it to start the wizard from on the new computer. Failing that try installing the KB896344 update on the new computer or if it is already installed try uninstalling it. The most common cause of this error is when one of the computers has this update installed and the other one doesn't. If that's the problem you have to make it match the status of the old computer. http://www.microsoft.com/downloads/d...displaylang=en -- Kerry Brown Microsoft MVP - Shell/User www.vistahelp.ca/phpBB2 "Ed Tice" wrote in message ... I recently purchased a new Dell PC and used the Files and Settings Transfer Wizard to transfer everything from my old Dell PC. On the old system, everything went fine and I placed the transfer files within a share on my new PC. I deleted all the files on my old PC. I then went to the new PC and started the Wizard again to import my old stuff. I got an error message that states that the Files and Settings were created with a previous version, and that I should retry using an updated version of the wizard. I already deleted everything from the old PC! My question is this: Have I really lost all those files and settings from the old PC? Or is there a way I can install the older version of the Wizard on the new PC? |
Thread Tools | |
Display Modes | |
|
|