If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Mouse question
Has anyone actually looked into a mouse and established the spec?
Specifically, how many slots in the wheel go by for a full screen move of the cursor at various settings in the GUI, (round numbers) I am trying to integrate a BowFlex with a PC via the mouse port and I am trying to get close on how many slots I need on the disk that I put on the main pulleys. I understand I will still need a way to stop the pulses to get the effect of picking up the mouse and recentering (a switch in the IR circuit) but I was just trying to get a head start on the speed. |
Ads |
#2
|
|||
|
|||
Mouse question
|
#3
|
|||
|
|||
Mouse question
On Sun, 06 Dec 2015 12:55:45 -0600, Paul in Houston TX
wrote: wrote: Has anyone actually looked into a mouse and established the spec? Specifically, how many slots in the wheel go by for a full screen move of the cursor at various settings in the GUI, (round numbers) I am trying to integrate a BowFlex with a PC via the mouse port and I am trying to get close on how many slots I need on the disk that I put on the main pulleys. I understand I will still need a way to stop the pulses to get the effect of picking up the mouse and recentering (a switch in the IR circuit) but I was just trying to get a head start on the speed. While I have never counted the slots, I periodically take my 6 or 8 apart for internal cleaning and they are all different slot number wise. Some have very few, comparatively, and some quite a lot. I'd say anywhere from 50 to 100. Most have single slot sensors and some have dual sensors. Your best bet is to count yours and make the BowFlex the same. I have to believe the interrupt count is similar even though the ball size and the shaft size varies. insert joke here ;-) I guess I will just have to do some trial and error testing. I was hoping there was a standard somewhere. I have had no joy searching on it so far tho. |
Thread Tools | |
Display Modes | |
|
|