If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help: Disk can't accessible.
1. Maxtor 40Gb - partitioned into 2 drives
2. Maxtor 40Gb - partitioned into 2 drives These two hard drives are connected to the on board ATA133 RAID connectors, and was created an Array for Performance - RAID 0 Stripe. I was previously running Windows XP Professional and was able to read and write all 4 partitions without any problem. However, Since I reinsalled the XP Professional due to some other problems, one of the partition has become inaccessible. When going into the Disk properties, its file system shows RAW. and when going into the Disk Management, it shows up as Healthy Basic Partition with an NTFS File System. I want to be able to access the data on the drive, is there any way I can fix this? Thank you. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
XP home file and printer sharing | Gulp | Networking and the Internet with Windows XP | 21 | December 9th 04 01:22 PM |
Low disk space | Haim Guivon | General XP issues or comments | 16 | October 23rd 04 12:09 AM |
view workgroup computers--workaround | Terry B. | Networking and the Internet with Windows XP | 17 | October 18th 04 05:17 AM |
Upgrading to a S-ATA disk with Asus P4PE - Help? | Andrew E. | General XP issues or comments | 1 | October 13th 04 06:24 PM |
Installing An Upgrade Version of Windows XP on a new Hard Disk | Ben West | General XP issues or comments | 2 | August 17th 04 12:01 PM |