Failing Video Cards

I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors through
DVI, the video cards installed on these systems are ASUS V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears that 2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks

Hi,

The ASUS V9520-X/TD/128MB FX5200 128MB DDR DVI TV-OUT cools passive.
That's not so good. If you have no fan in case, the graphic card getting
very hot.
So to solve problem is, install a fan in case or to take an active cooling
for graphic card.

Greets,
Wolla


"Clayton" wrote:

I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors through
DVI, the video cards installed on these systems are ASUS V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears that 2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks

And its allways possible you purchased a bad batch

"Clayton" wrote in message
...
I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors through
DVI, the video cards installed on these systems are ASUS V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears that
2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks

ATI caused the same type of problem with its visiontek line,lack of cooling
by
means of no fan(s),and small heat-sink.To solve it,one can,lightly sand the
bottom of the heat sink once removed.This greatly transfers heat to it,plus
adding a aux. fan below the card goes one step further(dont forget the paste
onto the sink),with these two remodees to any card,overheating simply wont
happen..

"Clayton" wrote:

I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors through
DVI, the video cards installed on these systems are ASUS V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears that 2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks

Thanks, I'd say it's a heat issue also.
The cheaper option is to put in a chassis fan, or should I replace the cards
with fans on them instead?
Should the chassis fans be installed to blow the air into the case or out of
the case?

Thanks



"Andrew E." wrote in message
...
ATI caused the same type of problem with its visiontek line,lack of
cooling
by
means of no fan(s),and small heat-sink.To solve it,one can,lightly sand
the
bottom of the heat sink once removed.This greatly transfers heat to
it,plus
adding a aux. fan below the card goes one step further(dont forget the
paste
onto the sink),with these two remodees to any card,overheating simply wont
happen..

"Clayton" wrote:

I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors through
DVI, the video cards installed on these systems are ASUS V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears that
2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks

Clayton wrote:
Thanks, I'd say it's a heat issue also.
The cheaper option is to put in a chassis fan, or should I replace the cards
with fans on them instead?
Should the chassis fans be installed to blow the air into the case or out of
the case?

Thanks


The easiest solution is to get a PCI slot fan and install below the
video card. They exhaust the air out of the case and can be installed
in a couple of minutes.
I used one with a video card that would overheat in a couple of minutes
and afterwards never had any problems. I could feel the heat from the
card in the exhaust air.


"Andrew E." wrote in message
...
ATI caused the same type of problem with its visiontek line,lack of
cooling
by
means of no fan(s),and small heat-sink.To solve it,one can,lightly sand
the
bottom of the heat sink once removed.This greatly transfers heat to
it,plus
adding a aux. fan below the card goes one step further(dont forget the
paste
onto the sink),with these two remodees to any card,overheating simply wont
happen..

"Clayton" wrote:

I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors through
DVI, the video cards installed on these systems are ASUS V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears that
2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks

oh really? now that's an option

Thanks


"Michael W. Ryder" wrote in message
...
Clayton wrote:
Thanks, I'd say it's a heat issue also.
The cheaper option is to put in a chassis fan, or should I replace the
cards with fans on them instead?
Should the chassis fans be installed to blow the air into the case or out
of the case?

Thanks


The easiest solution is to get a PCI slot fan and install below the video
card. They exhaust the air out of the case and can be installed in a
couple of minutes.
I used one with a video card that would overheat in a couple of minutes
and afterwards never had any problems. I could feel the heat from the
card in the exhaust air.


"Andrew E." wrote in message
...
ATI caused the same type of problem with its visiontek line,lack of
cooling
by
means of no fan(s),and small heat-sink.To solve it,one can,lightly sand
the
bottom of the heat sink once removed.This greatly transfers heat to
it,plus
adding a aux. fan below the card goes one step further(dont forget the
paste
onto the sink),with these two remodees to any card,overheating simply
wont
happen..

"Clayton" wrote:

I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors
through
DVI, the video cards installed on these systems are ASUS
V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears
that 2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks

On 22/08/2006 "Clayton" wrote:
Thanks, I'd say it's a heat issue also.
The cheaper option is to put in a chassis fan, or should I replace the cards
with fans on them instead?
Should the chassis fans be installed to blow the air into the case or out of
the case?

Thanks



"Andrew E." wrote in message
...
ATI caused the same type of problem with its visiontek line,lack of
cooling
by
means of no fan(s),and small heat-sink.To solve it,one can,lightly sand
the
bottom of the heat sink once removed.This greatly transfers heat to
it,plus
adding a aux. fan below the card goes one step further(dont forget the
paste
onto the sink),with these two remodees to any card,overheating simply wont
happen..

"Clayton" wrote:

I need some expert advice here as ASUS have no idea.

I built 7 systems for a customer running Samsung 21" LCD monitors through
DVI, the video cards installed on these systems are ASUS V9520-X/TD/128MB
FX5200 128MB DDR DVI TV-OUT

Over the last 12 months 5 of the video cards have failed, it appears that
2
resistors on the card have swollen up and the system can not boot.

Should I be using other cards with these monitors?

The Samsung monitor models are 213T

Any help on determining the cause of the problem would be appreciated

Thanks






Most chassis air flow recommendations a

1) Front fans: low and blow air into the chassis.

2) Back fans: High and blow air out of chassis.


Hot air rises and cool air falls.

--
---

Y.