If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Frames?
Hi, all. Just started with Windows XP, and I have found a disconcerting
problem when I am posting to a forum, or even a tech support question at some websites. I can't see the frames in which to post. I only have a long thin line with a slider, and I can see nothing that I try to post because it is "vertical." I have resorted to typing my text in Word and then pasting it into the "slider" because that is the only way I can post. Then of course, if I want to revise something, I have to cancel my post and do it all over again. Is this a glitch, a browser problem (I use Internet Explorer), or have I not done something to allow the frames to be seen? Any help you can give me will be much appreciated. -- Thank you for your support — Burrito Sister |
Ads |
#2
|
|||
|
|||
Frames?
Do you mean that, from top to bottom, the area to put text into is just too
tiny? You should be able to use your mouse to grasp the dividing line and drag until the window gets bigger. Experiment and see if that will help. Pop -- Perfection is not only elusive, it is also limited with unexpected and dangerous results for the idealist. "Burrito Sister" wrote in message ... Hi, all. Just started with Windows XP, and I have found a disconcerting problem when I am posting to a forum, or even a tech support question at some websites. I can't see the frames in which to post. I only have a long thin line with a slider, and I can see nothing that I try to post because it is "vertical." I have resorted to typing my text in Word and then pasting it into the "slider" because that is the only way I can post. Then of course, if I want to revise something, I have to cancel my post and do it all over again. Is this a glitch, a browser problem (I use Internet Explorer), or have I not done something to allow the frames to be seen? Any help you can give me will be much appreciated. -- Thank you for your support - Burrito Sister |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Since SP2, some ad frames in IE6 don't show up | Steve Portigal | Windows Service Pack 2 | 5 | November 28th 04 05:38 AM |
Help please- problem browser supporting frames | HayleyO | General XP issues or comments | 2 | September 29th 04 05:33 PM |
XP Network Bridge and Jumbo Frames? | Ray Schaefer | Networking and the Internet with Windows XP | 1 | September 21st 04 01:59 PM |
How do I print ONLY! content frames from Mirosoft MSDN help pages ?? | Frank Callone | General XP issues or comments | 10 | August 1st 04 05:07 AM |
How do I print ONLY! content frames from Mirosoft MSDN help pages ?? | Frank Callone | Windows XP Help and Support | 1 | July 31st 04 07:19 PM |