|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 27th 04, 07:39 PM
|
|||
|
|||
Com1 already in use
Windows XP Pro.
Modem connected on the serial port. Very often when I try to use the modem I get "Com1 already in use" Of course I have no other devices connected to com1, i.e. the IRQ is assigned only to Com1. I have already found a turnaround: I uninstall the com1 , restart Windows and re install Com1. Of course I don't like it. Any idea to solve in a better way ? Thanks Manlio Manlio Laschena s/y Amarose http://Delphi-Jedi.org 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DUN Device Missing (COM1) | Gary Tomlinson | Hardware and Windows XP | 3 | August 16th 04 08:44 PM |
| Mapping a USB cable to COM1 | MJM | Hardware and Windows XP | 0 | August 12th 04 03:15 AM |
Linear Mode
