If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CDR won't open
The paper clip trick got my disc out, but the tray still
won't respond to commands to open. Suggestions? |
Ads |
#2
|
|||
|
|||
CDR won't open
Drawer is probably out of alignment. This is due in most cases to the user
pushing on the drawer to close it instead of using the button that opens *AND* closes the tray. the gears that control the tray are made of a relatively soft plastic. You could try to have it realigned, but considering that labor alone is probably in the neighborhood of $65 per hour, it would be cheaper to just buy a new unit. In the future , if you want a long service life from your unit, do not close the tray by pushing on it. Use the same button that opens it. This will keep the tray in proper alignment. Bobby "Eugene Jones" wrote in message ... The paper clip trick got my disc out, but the tray still won't respond to commands to open. Suggestions? |
Thread Tools | |
Display Modes | |
|
|