If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"Disk 1; dynamic; unreadable"
Hello:
On my PC, I used to have a 40 GB HDD (Disk 0) partitioned in to Drive C and Drive D. Drive C had Windows XP O/S and Drive D only had data. I bought a new 160 GB HDD, installed it as a slave drive, and then transfed all data from drive D into it. After the data transfer, I was able to see and work on all my data on the 160 GB drive. I decided to re-installed Windows XP on the old 40 GB drive which was formated in NTFS. After installation, I could not see the 160 GB drive. The dish management utility shown that the 160 GB drive was dynamic and unreadable. Wish somebody would know how to make the 160 GB drive visible and readable again. Many thanks -Son Dinh |
Ads |
Thread Tools | |
Display Modes | |
|
|