If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Lexmark Z517 problem solved!
Thanks to posts I found in this group, and a little luck, I solved this
problem. Briefly: I bought a Lexmark Z517 from Woolworths for very cheap. Got it home, and the Windows PnP insisted it was a "Z600 series". Could NOT get it to work, and the Lexmark "help" section was a complete waste of time. I discovered that some Z517s were shipped with the incorrect firmware on them (hence windows thinking it's a Z600 you're plugging in). Here's what I did. 1. Removed the printer from my system and uninstalled the Z517 software. 2. Rebooted. 3. Downloaded from the Lexmark website the generic Z600 drivers. 4. Unzipped and installed them. 5. Rebooted again. And hey presto! It all works. Mainly just posting this as it may help others in the same situation I found myself in. Best to all John |
Ads |
#2
|
|||
|
|||
Lexmark Z517 problem solved!
Hi,
thanks for this solution. The same problem occurs with printers of this type baught in germany. I did as you said and voila - it works! Thanks, Felix " wrote: Thanks to posts I found in this group, and a little luck, I solved this problem. Briefly: I bought a Lexmark Z517 from Woolworths for very cheap. Got it home, and the Windows PnP insisted it was a "Z600 series". Could NOT get it to work, and the Lexmark "help" section was a complete waste of time. I discovered that some Z517s were shipped with the incorrect firmware on them (hence windows thinking it's a Z600 you're plugging in). Here's what I did. 1. Removed the printer from my system and uninstalled the Z517 software. 2. Rebooted. 3. Downloaded from the Lexmark website the generic Z600 drivers. 4. Unzipped and installed them. 5. Rebooted again. And hey presto! It all works. Mainly just posting this as it may help others in the same situation I found myself in. Best to all John |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lexmark Z517 | Barry | Printing and Faxing with Windows XP | 4 | January 10th 06 08:59 PM |
James A. Eshelman: Power Down problem solved | Shelly F | General XP issues or comments | 1 | December 15th 05 02:14 AM |
A "right click" problem solved.... | Jim L. | General XP issues or comments | 3 | March 31st 05 08:29 AM |
Lexmark x125 printer problem | burns | Printing and Faxing with Windows XP | 5 | September 8th 04 07:28 PM |
Partitioning hasn’t solved my problem | mark | Windows XP Help and Support | 1 | September 2nd 04 01:47 AM |