|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 26th 04, 11:49 PM
|
|||
|
|||
Lost connection after installing SP2
After installing SP2,i can only access the internet for about 5 mins.I have
to keep rebooting to gain access. Any Ideas??? 
|
| Ads |
|
#2
December 27th 04, 06:44 PM
|
|||
|
|||
|
Lost connection after installing SP2
the netsh command in SP2 can rebuild the Winsock catalog. Open the command
prompt and type: netsh winsock reset catalog then press ENTER. -- Mark L. Ferguson (NOT an MS-MVP) marfers notes for windows xp http://www.geocities.com/marfer_mvp/chatNotes.htm .. "Gozzy" wrote in message news  After installing SP2,i can only access the internet for about 5 mins.I have to keep rebooting to gain access. Any Ideas???
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cannot read cdroms after installing winXP SP2 | Nabil | Hardware and Windows XP | 0 | October 23rd 04 02:43 AM |
| Clean XP Pro SP2 Installation Wrecks Internet Connection | Jude Lucien | Windows Service Pack 2 | 4 | September 28th 04 05:57 PM |
| intermittent lost network connection after SP2 | Claude | Windows Service Pack 2 | 6 | September 10th 04 11:15 AM |
| Firewire 1394 speed/connection problem | Kevin Brault | Networking and the Internet with Windows XP | 4 | August 22nd 04 10:31 PM |
Linear Mode
