|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 18th 07, 09:24 AM
posted to microsoft.public.windowsxp.general,comp.periphs.scanners,microsoft.public.windowsxp.photos,microsoft.public.windowsxp.hardware,microsoft.public.windowsxp.help_and_support
|
|||
|
|||
Installing a WIA Device Without Port Assignment
Hello,
Is there a way to assign no serial/parallel port to a WIA device during installation? Background: We are developing SW for an X-Ray device. We thought it's a good idea to provide the images using WIA. What we wonder about is that we must dedicate a serial or a parallel port for our WIA device. However, the device delivers the images via Ethernet and there's no need to capture any port. Thank you in advance, Kirill 
|
| Ads |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
