If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Installing a New Western Digital Drive
My C-drive is a WCD1200JB, IDE. I'm trying to install a new one,
WCD1200JB also, as a slave. The drive on the end of the cable is the old drive. The slave, the new one, is in the middle of the cable. I have no pins used on the new drive, and one jumper over the two pins one set away from the power plug. When I fire up, the machine sees both master and slave in bios, but in the OS there is no trace of the new drive. What's wrong here? |
Ads |
Thread Tools | |
Display Modes | |
|
|