|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
December 7th 03, 09:09 PM
|
|||
|
|||
USB flash card reader
I've got a USB card reader for my digital camera. It
worked a few weeks ago. Now it shows up in the device list as "unknown" device. Everywhere I go says "you don't need drivers, windows XP has drivers built-in" How on Earth do I make it stop saying unknown device and make XP's built-in driver load again? 
|
| Ads |
|
#2
December 7th 03, 09:10 PM
|
|||
|
|||
|
USB flash card reader
"Einar Offerdahl" wrote in message
... I've got a USB card reader for my digital camera. It worked a few weeks ago. Now it shows up in the device list as "unknown" device. Everywhere I go says "you don't need drivers, windows XP has drivers built-in" How on Earth do I make it stop saying unknown device and make XP's built-in driver load again? Have you tried the following: 1. disconnect your reader and reboot computer. 2. Insert a "good" flash card into the reader, then connect it to the computer -- PA
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
