|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 15th 03, 04:34 AM
|
|||
|
|||
Cannot install DV camcorder via Firewire CODE 28
I have a Sharp Vl-NU100 MiniDV camcorder connected
through a firewire port (updated the drivers and reinstalled the card) but when I try to recognized the camcorder it says sharp miniDV and then when the status bar comes up it says there is an error in loading it and that it was not installed properly. Then I get a code 28. How do i fix this? 
|
| Ads |
|
#2
April 15th 03, 02:25 PM
|
|||
|
|||
|
Cannot install DV camcorder via Firewire CODE 28
Hello
Does that software support what ever OS that you are you using find that out 1st Alvin Lain wrote: I have a Sharp Vl-NU100 MiniDV camcorder connected through a firewire port (updated the drivers and reinstalled the card) but when I try to recognized the camcorder it says sharp miniDV and then when the status bar comes up it says there is an error in loading it and that it was not installed properly. Then I get a code 28. How do i fix this?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
