![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hi,
More Update: I replaced every one of those 2200/6.3V with new Nichicon 2200uf 10V 105 deg. caps (verified good by testing them), but that did not fix the problem. The symptoms are exactly the same as I described in my original post. Note: I also replaced some other caps that had higher than normal ESR (eg. 220uf 16V caps). Note: I measured in circuit the +5V and +12V voltage sources, and both were "clean" (scoped) and at the proper level. Without a schematic, there isn't much more I can do. I have decided to abandon this repair attempt. John |
Ads |
Thread Tools | |
Display Modes | |
|
|