If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Problem installing a new video card
I tried to install a new video card in my computer. The
instructions told me to uninstall any drivers from the previous card that may conflict with the new card. I tried to do so, but only wound up disabling the basic vga driver. Now I cannot see anything once Windows boots. I tried using my S-video output from the new card to view it on my TV, but the display was very poor and it appeared as if the verticle hold was not working. I am at a loss at to what I should do to enable the vga driver so I can install the new driver. Any help would be appreciated |
Ads |
#2
|
|||
|
|||
Problem installing a new video card
Nate,
Try booting into safe mode to install the driver for your video card. -JFD "Nate" wrote in message ... I tried to install a new video card in my computer. The instructions told me to uninstall any drivers from the previous card that may conflict with the new card. I tried to do so, but only wound up disabling the basic vga driver. Now I cannot see anything once Windows boots. I tried using my S-video output from the new card to view it on my TV, but the display was very poor and it appeared as if the verticle hold was not working. I am at a loss at to what I should do to enable the vga driver so I can install the new driver. Any help would be appreciated |
#3
|
|||
|
|||
Problem installing a new video card
Nate,
Try booting into safe mode to install the driver for your video card. -JFD "Nate" wrote in message ... I tried to install a new video card in my computer. The instructions told me to uninstall any drivers from the previous card that may conflict with the new card. I tried to do so, but only wound up disabling the basic vga driver. Now I cannot see anything once Windows boots. I tried using my S-video output from the new card to view it on my TV, but the display was very poor and it appeared as if the verticle hold was not working. I am at a loss at to what I should do to enable the vga driver so I can install the new driver. Any help would be appreciated |
Thread Tools | |
Display Modes | |
|
|