If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
RasMan & NDISWAN problem
I recently encountered an error which has stopped my dial
up networking from working completely. Originally the RasMan would not start, which meant every time I tried to use the Modem, the system would indicate the modem was busy. I ended up performing a complete XP repair install, followed by installation of SP1. After this the modem can dial, however when it starts to authenticate, it hangs up, and indicates Error 6: Handle is invalid. I have tried resetting the TCP/IP protocol using the netsh int ip reset command, as well as any other relevant knowledge base article I could find. The Event log still indicates that RasMan failed to start because NDISWAN could not be opened. Before I completely wipe my HD and reinstall, is there anything else I can try? Regards, Dave |
Ads |
#2
|
|||
|
|||
RasMan & NDISWAN problem
Same here and from all my surfing I only know that reinstalling the os is the only solutioN!!!!! :S
|
Thread Tools | |
Display Modes | |
|
|