If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
stay'n online
Hi !
Most will think this is silly but I dont know how to stay online. It keeps kick'n me off even though I set my stat to busy or away. An answer would be very much appreciated! |
Ads |
#2
|
|||
|
|||
stay'n online
If your using Zone Alarm ( or possibly another firewall) check the settings
.... you can also try reregistering the following files Verify that the Microsoft Cryptographic Services Service Is Started To verify that the Cryptographic Services service is started (and to start it if it is not): 1. Click Start, and then click Run. 2. In the Open box, type cmd, and then click OK. 3. At the command prompt, type net start cryptsvc, and then press ENTER. 4. Type exit to quit Command Prompt. Register .Dll Files Re-register the following .dll files: Softpub.dll Wintrust.dll Initpki.dll Dssenh.dll Rsaenh.dll Gpkcsp.dll Sccbase.dll Slbcsp.dll Cryptdlg.dll To do so: 1. Click Start, and then click Run. 2. In the Open box, type cmd, and then click OK. 3. At the command prompt, type the following lines and press ENTER after each line: regsvr32 softpub.dll regsvr32 wintrust.dll regsvr32 initpki.dll regsvr32 dssenh.dll regsvr32 rsaenh.dll regsvr32 gpkcsp.dll regsvr32 sccbase.dll regsvr32 slbcsp.dll regsvr32 cryptdlg.dll 4. Click OK when you receive the message that DllRegisterServer in FileName succeeded. 5. Type exit to quit Command Prompt. "Frank" wrote in message ... Hi ! Most will think this is silly but I dont know how to stay online. It keeps kick'n me off even though I set my stat to busy or away. An answer would be very much appreciated! |
Thread Tools | |
Display Modes | |
|
|