|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 16th 05, 11:08 AM
|
|||
|
|||
New HDD: "New hardware" wizard still appears as my drive works fine
Hi,
I recently added a HDD (Maxtor) to my PC. The first time i turned on my PC with this new drive, the "new hardware" wizard reconized my HDD but couldn't find the drivers. But now my HDD is well-reconized by the system and works fine. My problem is that the wizard still appears each time i turn on my computer. So how can i force it to "forget" my "new" HDD? Thanks in advance, Olivier 
|
| Ads |
|
#2
January 16th 05, 11:57 AM
|
|||
|
|||
|
New HDD: "New hardware" wizard still appears as my drive works fin
When the Wizard appears the next time, check that you choose the option 'do
not attempt to install this device again' [or some similar wording]. "Olivier Theulé" wrote: Hi, I recently added a HDD (Maxtor) to my PC. The first time i turned on my PC with this new drive, the "new hardware" wizard reconized my HDD but couldn't find the drivers. But now my HDD is well-reconized by the system and works fine. My problem is that the wizard still appears each time i turn on my computer. So how can i force it to "forget" my "new" HDD? Thanks in advance, Olivier
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Drive Letters | Paul | The Basics | 10 | November 8th 04 07:10 PM |
| Dead Hard Drive | Ben Williams | Hardware and Windows XP | 10 | November 5th 04 12:45 PM |
| Hard Drive Errors | Wade Waldron | Windows XP Help and Support | 1 | October 25th 04 12:01 PM |
| WinXP, Dual Boot, New Hard Drive | jimbo | Hardware and Windows XP | 7 | October 10th 04 12:47 AM |
| renaming drives | Mark | Windows XP Help and Support | 3 | October 2nd 04 07:15 PM |
Linear Mode
