If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
unable to see each computer after installing xp pro
Subject: Have you tried this????
From: "RickC" Sent: 4/23/2003 5:23:53 PM Take a look at my Windows XP post ( a few below yours) sounds very similar. You can try the arp fix and see if it works for you too. Would be interesting to fine out a solution to this.... Rick -----Original Message----- two machines, one with xp home, one with pro, both connected to linksys router and dsl internet access works via this router. just installed the os for the pro machine and now i cannot see either computer from either machine. windows firewall is disabled and no changes have been made to the router and there is not a third party firewall installed. network worked finwe until hard drive was replaced and full ver of xp pro was installed with sp1. i have tried to change the network name on both machines, changed the names, removed the network cards, assigned ip addresses. thanks in advance. -shelby . |
Ads |
Thread Tools | |
Display Modes | |
|
|