|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 27th 10, 10:11 PM
posted to microsoft.public.windowsxp.hardware
|
|||
|
|||
Camera not recognized?
I have a Canon PowerShot SD750, it does not need drivers for XP, but on one
particular computer, a Dell Precision 390, when you plug it into the USB, it goes into the "new hardware found" routine, looks for drivers, says none found, hardware not installed, and the camera does not show up in My Computer. I've tried the USB ports in front and back, and other cameras do work on it. and the camera is recognized on other computers. Also updated bios and chipset on the computer from the dell web site. Anything I can do about this? 
|
| Ads |
|
#2
May 27th 10, 10:49 PM
posted to microsoft.public.windowsxp.hardware
|
|||
|
|||
|
Camera not recognized?
"dlw" wrote in message
... I have a Canon PowerShot SD750, it does not need drivers for XP, but on one particular computer, a Dell Precision 390, when you plug it into the USB, it goes into the "new hardware found" routine, looks for drivers, says none found, hardware not installed, and the camera does not show up in My Computer. I've tried the USB ports in front and back, and other cameras do work on it. and the camera is recognized on other computers. Also updated bios and chipset on the computer from the dell web site. Anything I can do about this? Remove all USB hardware, Uninstall all USB drivers(including the MS ones) in Device Manager. Reboot. so they reinstall reattach USB devices, camera first. Don't use a hub until its working. HTH
|
|
#3
May 27th 10, 10:49 PM
posted to microsoft.public.windowsxp.hardware
|
|||
|
|||
|
Camera not recognized?
"dlw" wrote in message
... I have a Canon PowerShot SD750, it does not need drivers for XP, but on one particular computer, a Dell Precision 390, when you plug it into the USB, it goes into the "new hardware found" routine, looks for drivers, says none found, hardware not installed, and the camera does not show up in My Computer. I've tried the USB ports in front and back, and other cameras do work on it. and the camera is recognized on other computers. Also updated bios and chipset on the computer from the dell web site. Anything I can do about this? Remove all USB hardware, Uninstall all USB drivers(including the MS ones) in Device Manager. Reboot. so they reinstall reattach USB devices, camera first. Don't use a hub until its working. HTH
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
