If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CD Burner and DVD burner
Hi,
Do not put both burners on the same IDE channel. IDE does not support full duplex and if both are active on the same channel performance will be badly degraded. http://www.nero.com/en/helptool/246.htm I have 2 hard drives and a CD and a DVD burner. Each HDD is set to Master and the burners are slaves. Regards, Tim -----Original Message----- Hi all, I have an Asus 52x24x52 cd burner. And just got a pioneer A06 DVD burner yesterday. I read on one site the DVD burner should be set as master. (The CD burner is master atm, and the DVD the slave). Would it still be better as is? Since the CD burner is faster than the DVD burner? Or should I change them round? I've got plenty of ram ( 1GB DDR). And Windows XP. I would prefer to keep the CD burner,since the DVD burner's only 16x to CD. and 32x read What do you think? . |
Ads |
#2
|
|||
|
|||
CD Burner and DVD burner
Well i had a burner and normal dvd on the same ide.
No probs at all. Well you're not meant to put either on the main ide with a hdd either. As the hdd is slower than both dvd and the burner. Do you know whatya talking bout anonymous? full duplex of what exactly? lol. If you dont, dont bother answering with stupid answers. Well I use the Asus P4P800. Which has 2 masters and 2 slaves (due to the ide and sata). The main ide is an 80gb on the secondary the burner and burner. On the secondary master ide a 120gb sata. by itself. So the 80 and the 120 gb hdd's are on separate channels, coz 1 is ide and the other is on a sata connection. wrote in message ... Hi, Do not put both burners on the same IDE channel. IDE does not support full duplex and if both are active on the same channel performance will be badly degraded. http://www.nero.com/en/helptool/246.htm I have 2 hard drives and a CD and a DVD burner. Each HDD is set to Master and the burners are slaves. Regards, Tim -----Original Message----- Hi all, I have an Asus 52x24x52 cd burner. And just got a pioneer A06 DVD burner yesterday. I read on one site the DVD burner should be set as master. (The CD burner is master atm, and the DVD the slave). Would it still be better as is? Since the CD burner is faster than the DVD burner? Or should I change them round? I've got plenty of ram ( 1GB DDR). And Windows XP. I would prefer to keep the CD burner,since the DVD burner's only 16x to CD. and 32x read What do you think? . |
Thread Tools | |
Display Modes | |
|
|