If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Solved my problem! Maybe yours too
that lead is nothing to do with the video card, it is for pentium 4
processors only, which require higher startup current which if they don't get can fry the CPU/motherboard Paul K wrote: Hi, I don't know if this will help or not-- I had much the same problem when installing a new video card. I even went through the same driver problem. I contacted the card manufacturer, but he couldn't help. However, he did comment that 1)My LCD monitor couldn't handle the video card frequency, but it didn't work when I tried it on my CRT monitor either. or 2) I should check my power supply wattage to make sure I had enough power getting to the new power hungry video card. It seems that 350 watt power supplies may only be supplying 180 watts under load! On my way to replacing my power supply, I noticed a connector that the computer maker never had connected to the Mother board. Apparently the lower end video cards don't require the extra current that the newer higher performing ones do, so they didn't hook this one up! It looks like a small cube and has four pins and connects to the "core processor" connector on the mother board. It sure solved my problem, the monitor goes to the Welcome screen now instead of going black! - I hope it helps you out. -----Original Message----- Don't know what to do.... My computer will boot up, the monitor turns on and shows some info about the NVideo card, then shows some info about the hard drives, then goes to a Windows XP screen with a set of green scrolling lights. After that, instead of the monitor showing my desktop, it goes into its "energy saver" mode, as if it's not receiving a signal from the computer. However, there are some things I can do even though the monitor is black that indicates to me that the computer itself is still running: 1. I can still open the CD/DVD drive bay, and if I insert a CD, it begins spinning in the CD as though it's trying to access information 2. If I push the power button on the front of the case, the computer spins a little more, I hear the Windows power down music, and the computer shuts off. I tried hooking the monitor back up to my old computer (ACER, PII, 300 mhz) and it works fine. I have also downloaded all the critical updates to Windows XP that Microsoft Windows Update has indicated are available at this time. This was completed over a week ago and the computer has operated with no problems since then (until today). I don't know what happened, but does anyone know what solutions I should try? . |
Ads |
Thread Tools | |
Display Modes | |
|
|