If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Please help
When I try to carry out the Scandisc operation I am told that the scan
requires full access and that the scan will be carried out on the next boot up (this I know is correct). But when during the boot up the PC gets to the point where it should start the scan I get the blue screen, and I get the error message "Cannot open the volume for direct access", the boot then carries on to completion. I don't appear to have any other errors at the moment except that I cannot enter the start up options at the start of the boot ie Safe Mode. Perhaps the problems are linked. Please help. |
Ads |
Thread Tools | |
Display Modes | |
|
|