If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
System Restore does not work
For some time now when I use System Restore it goes through the motions,
rebooting, etc., but always ends up telling me that it could not restore to the selected point, to choose another one. If I do choose another one, I always get the same result. I am using XP Home SP3. Help would be appreciated. Thank you. -- medwayfire.org |
Ads |
#2
|
|||
|
|||
System Restore does not work
In
=?Utf-8?B?QnVkZHlib3k=?= wrote: For some time now when I use System Restore it goes through the motions, rebooting, etc., but always ends up telling me that it could not restore to the selected point, to choose another one. If I do choose another one, I always get the same result. I am using XP Home SP3. Help would be appreciated. Thank you. I've found that doing the restore in safe mode is much more likely to work. -- Bert Hyman St. Paul, MN |
#3
|
|||
|
|||
System Restore does not work
=?Utf-8?B?QnVkZHlib3k=?= wrote
in : For some time now when I use System Restore it goes through the motions, rebooting, etc., but always ends up telling me that it could not restore to the selected point, to choose another one. If I do choose another one, I always get the same result. I am using XP Home SP3. Help would be appreciated. Thank you. Boot your machine to Safe Mode (Hit F8 while system boots up), and then do a System Restore. HTH, John |
Thread Tools | |
Display Modes | |
|
|