If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
complex yet interesting chalange
here is my projects in the 22 unit warehouse building (kinda like a university dorm) i have to supply the internet, BUT not allowed to run wires to every room do to the fire inspectors so i will have to partially do at least 2 wifi antennas and some lan hookups i use a computer with ICS instead of a router to supply IP's (for bandwidth management reasons) problem1 : they all have to be on the same subnet, in other words i can not just run wifi routers that give out new sets of IP's how do i do that ? can i use a wifi router like i would a wired switch ? what option is that in the routers settings ? an alternative option would be to have 1 NIC card and 2 wifi cards in the ICS computer, again not sure how to tell ICS to use 3 network cards for ICS output, is that even possible ? problem2: for bandwidth management and monitoring i try to use Antamedia Bandwidth Manager V1.0.0 (full version, not trial) reason is in this building we have only a DSL 2000/800 available, and if someone is using utorrent full blast every one else is not getting even a page open is there a better solution to do this with ? i cant get that to work as of yet, it wont even monitor any traffic outside the computer its installed on, not alone having the option to limit traffic to each IP or MAC individually tried netlimiter , that i had even less luck with |
Thread Tools | |
Display Modes | |
|
|