If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cannot start print spooler...error 1068
If you go to administrative tools in the control panel
and go to services, scroll down to print spooler. Right click and click properties, click the tab dependencies and you will notice the print spooler depends on the service Remote Procedure Call(RPC). Go back to the service menu and scroll down to remote procedure call (RPC), right click and click start. This will start the RPC service allowing you to start the print spooler. If you want them both to start at startup, right click, properties, general, and change startup type to automatic for both of them. If the RPC start function is greyed out, you will have to go to the RPC properties, and select either manual startup(starts when you manually make it) or sutomatic(starts at startup) -----Original Message----- I'm trying to install the drivers for my new Lexmark x75 printer. But the setup can't continue because it says the print spooler must be started. I try to start it but i get the "error 1068: the dependency service or group failed to start". Any suggestion, fixes,...? . |
Ads |
Thread Tools | |
Display Modes | |
|
|