If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Network one XP computer with LAN running on 2K
-----Original Message-----
My office network runs on Win2K. I have just loaded XP on one computer. Network does not recognize the computer with XP nor does XP computer recognize the network. I ran Network Wizard in XP. Disabled and deleted the bridging problem. Any suggestions? . Hi Mike, First thing can you ping the other system, are they on the same network? if you can't ping it then it's most likely a physical problem. On any W2K system go to start run type cmd, this will bring up a dos box at the cm prompt type ipconfig /all, it will give you the IPO and subnet of the system you are on write this down. Now go do the same thing on the XP system if it's the same subnet then try to ping the w2k system you were just on by typing ping space the IP address example ping 10.0.0.14 if you get a reply then you are physically and logically connected on the same network. If it's not the same make sure you have under the My Network, Properties, Local or wireless properties TCP/IP "Obtain an IP address automatically" is selected. Then go to the CMD again and type ipconfig /release then after it releases type ipconfig /renew now try to ping. At this point let us know how you're doing |
Ads |
Thread Tools | |
Display Modes | |
|
|