If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Network Bridge STP troubleshooting tool
Hi,
I seeke for some Network Bridge's STP troubleshooting technique or tool. Is there any tool which could show me STP interface statuses such as blocking, forwarding, listening etc.? I tried to watch STP traffic with network monitor, but non has been captured - so network monitor either did not captured anything, or have no parser for the packets (but no raw ethernet traffic has been captured) or the Windows XP nor 2003 Network Bridge generated STP BPDUs. O. |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installing default network printer for all users | Gilles | Printing and Faxing with Windows XP | 2 | April 8th 05 07:53 AM |
System reboots after creating network bridge | Luis el santcugatenc | Networking and the Internet with Windows XP | 1 | October 6th 04 10:42 AM |
Sharing & "Entire Network" ?? | Jim | Networking and the Internet with Windows XP | 11 | September 25th 04 10:24 PM |
Cannot make a Network Bridge or use Network Setup Wizard | John | Networking and the Internet with Windows XP | 4 | August 14th 04 07:23 PM |
My PC has connected to local and dial up network simulaneously | Networking and the Internet with Windows XP | 0 | July 30th 04 01:28 AM |