If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
help - safe mode doesn't work
Can someone help -
I have a flat screen monitor set up as plug and play monitor and ATI Radeon 9600 video card with new drivers. When I boot to safe mode - no picture, message "video signal out of range" from monitor. If I boot to "VGA enabled" it's ok, but then I'm not in safe mode, as all the extraneous items seem to load. This is a new problem since going to XP pro from 98SE - is there something else I need to adjust? Thanks for any help Bruce |
Ads |
#2
|
|||
|
|||
help - safe mode doesn't work
Bruce A. Evans wrote:
I have a flat screen monitor set up as plug and play monitor and ATI Radeon 9600 video card with new drivers. When I boot to safe mode - no picture, message "video signal out of range" from monitor. I would assume that's because flatscreen (LCD/TFT/etc.) monitors are set to a fixed resolution. |
Thread Tools | |
Display Modes | |
|
|