If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Launching Screen Saver & setting it's Priority
If I launch my screensaver (by clicking on it's respective icon), it runs at
full speed, with priority = ABOVENORMAL. However, if the screensaver launches by itself (due to the wait interval in the control panel), it is painfully slow. Is there a way to change the startup priority of a screensaver? I've tried this command from the cmd prompt: start /ABOVENORMAL myscreensaver.scr -S This launches a new command window...does nothing. If I enter this from the cmd prompt: myscreensaver.scr -S It runs fine. Why is the start command not running my screen saver? Is there another way to have it automatically run in ABOVENORMAL priority? |
Ads |
Thread Tools | |
Display Modes | |
|
|