If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
hard drive
i have a HP a324y desktop. about a month ago i added a 500gb WD harddrive
along with an existing 40gb WD drive. The 40 gig is jumpered at cs and the added drive is jumped to the 2nd 2 pins. all worked well. I wanted to upgrade the memory. The 2 new 512gb memory 1 worked 1 did not. At start up it kept cycling at startup. To condense the story i replaced the bad pc. When i got the new stick the computer starts and freezes on hp invent logo. After playing for some time I removed the 2nd hard drive and all works well. I called and got the hard drive replace thinking that was the problem. The new 1 also does the same. I tried moving jumpers, and also changed the ribbon cable. Works well until I plug in the 2nd drive. Any one have any thoughts? Thank you much. |
Ads |
Thread Tools | |
Display Modes | |
|
|