|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 15th 04, 11:29 AM
|
|||
|
|||
Boot problems
When I attach a USP printer, windows XP does not boot. The screen remains black and the blinking cursor is in the upper left corner so I can not even get to the Setup menu or Startup menu. If I detach the cable, the boot process continues properly. If I
attach the printer after the boot process, I have no problems printing untill I have to restart. Than the system hangs again and will not boot. Device manager shows no conflicts when the printer is attached. 
|
| Ads |
|
#2
April 15th 04, 11:31 AM
|
|||
|
|||
|
Boot problems
Possibly an insufficient PSU?
-- Cari (MS-MVP Windows Client - Printing, Imaging & Hardware) www.coribright.com "Ele" wrote in message ... When I attach a USP printer, windows XP does not boot. The screen remains black and the blinking cursor is in the upper left corner so I can not even get to the Setup menu or Startup menu. If I detach the cable, the boot process continues properly. If I attach the printer after the boot process, I have no problems printing untill I have to restart. Than the system hangs again and will not boot. Device manager shows no conflicts when the printer is attached.
|
|
#3
April 15th 04, 11:46 AM
|
|||
|
|||
|
Boot problems
Possibly an insufficient PSU?
-- Cari (MS-MVP Windows Client - Printing, Imaging & Hardware) www.coribright.com "Ele" wrote in message ... When I attach a USP printer, windows XP does not boot. The screen remains black and the blinking cursor is in the upper left corner so I can not even get to the Setup menu or Startup menu. If I detach the cable, the boot process continues properly. If I attach the printer after the boot process, I have no problems printing untill I have to restart. Than the system hangs again and will not boot. Device manager shows no conflicts when the printer is attached.
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
