If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Scanner does not appear in scanners and cameras
I have a Visioneer Roadwarrior scanner that I installed. It supposedly
supports TWAIN and WIA. I was able to successfully install it. However it does not appear in the scanners and cameras in control panel. I have made sure that the windows image acquisition (WIA) service is started and set to Automatic. I have also tried using wiaacmgr.exe but it reports the following: The computer cannot detect the scanner or camera. I have tried to completely uninstall the scanner, reboot, then reinstall it. The same thing happens. How can I fix the WIA for scanners/cameras? Thanks Mike |
Ads |
#2
|
|||
|
|||
Scanner does not appear in scanners and cameras
And what mystery version of the scanner would it be?
http://support.visioneer.com/default...ategory=mobile "eljainc" wrote in message ... I have a Visioneer Roadwarrior scanner that I installed. It supposedly supports TWAIN and WIA. I was able to successfully install it. However it does not appear in the scanners and cameras in control panel. I have made sure that the windows image acquisition (WIA) service is started and set to Automatic. I have also tried using wiaacmgr.exe but it reports the following: The computer cannot detect the scanner or camera. I have tried to completely uninstall the scanner, reboot, then reinstall it. The same thing happens. How can I fix the WIA for scanners/cameras? Thanks Mike |
#3
|
|||
|
|||
Scanner does not appear in scanners and cameras
There is no mystery version. It is the Visioneer Roadwarrior scanner.
I have tried the drivers that are listed for the Roadwarrior, which apparently are the same as those shipped with the unit. Nov 7, 3:13*am, "DL" wrote: And what mystery version of the scanner would it be?http://support.visioneer.com/default...ategory=mobile "eljainc" wrote in message ... I have a Visioneer Roadwarrior scanner that I installed. It supposedly supports TWAIN and WIA. I was able to successfully install it. However it does not appear in the scanners and cameras in control panel. I have made sure that the windows image acquisition (WIA) service is started and set to Automatic. *I have also tried using wiaacmgr.exe but it reports the following: The computer cannot detect the scanner or camera. I have tried to completely uninstall the scanner, reboot, then reinstall it. The same thing happens. How can I fix the WIA for scanners/cameras? Thanks Mike |
Thread Tools | |
Display Modes | |
|
|