If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
blank disc not reading in drive
When i try to burn a cd the drive is not reading blank disc.
Its fine on all other discs. any ideas ? |
Ads |
#2
|
|||
|
|||
blank disc not reading in drive
|
#3
|
|||
|
|||
blank disc not reading in drive
Format the CD if you are trying to directly save to the CD. You will also
need packet writing software such as Nero "INCD" or Roxio "Drag to Disk". -- Regards, Richard Urban aka Crusty (-: Old B@stard :-) If you knew as much as you think you know, You would realize that you don't know what you thought you knew! "zola 25" zola wrote in message ... When i try to burn a cd the drive is not reading blank disc. Its fine on all other discs. any ideas ? |
#4
|
|||
|
|||
blank disc not reading in drive
Short on info here. Exactly what program cannot read the disc? Windows
explorer cannot see blank discs. "zola 25" zola wrote in message ... When i try to burn a cd the drive is not reading blank disc. Its fine on all other discs. any ideas ? |
#5
|
|||
|
|||
blank disc not reading in drive
zola 25 wrote: When i try to burn a cd the drive is not reading blank disc. Its fine on all other discs. any ideas ? When you insert a blank cd, the drive attempts to read the ATIP (Absolute Time In Pre-groove), which contains important information about the disc, e.g. capacity and supported write speeds. The ATIP is stored at the very inner edge of the disc, so the laser head has to move to the extreme end of it's travel to read the ATIP. It's not uncommon for old grease and dust to accumulate at the ends of the guide rails and cause the drive to have problems reading the ATIP. I have repaired several CD writers with your symptoms by opening the drive, cleaning the guide rails with isopropyl alcohol on a q-tip, and re-lubricating them with a *tiny* amount of white lithium grease. In one case I also had to shave about 1mm off the rubber bump-stop to allow the laser head to travel a little further to access the ATIP. Sunny |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drive E not reading properly | Kitypotpye | General XP issues or comments | 0 | January 24th 05 01:45 AM |
Drive Letters | Paul | The Basics | 10 | November 8th 04 07:10 PM |
Dead Hard Drive | Ben Williams | Hardware and Windows XP | 10 | November 5th 04 12:45 PM |
Clone Won't boot | jimbo | Hardware and Windows XP | 10 | November 2nd 04 03:36 PM |
Two "expert" issues I must solve before upgading | Jeff W | New Users to Windows XP | 29 | September 12th 04 03:38 PM |