|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 21st 05, 02:47 PM
|
|||
|
|||
Device Manager
I recently changed my motherboard and had to repair install XP, then I DL'd
SP2. Now when I go to device manager, my monitor and cpu are showing up twice. Anyone have any idea about this? Any help will be greatly appreciated. 
|
| Ads |
|
#2
January 21st 05, 03:25 PM
|
|||
|
|||
|
Device Manager
Monitor may be shown twice if the video card happens to have two connection
ports (VGA and DVI ports count!) CPU may show up as two if the processor (CPU) supports the "Hyper Threading" techicnology from Intel. "Phil Imperiale" wrote in message ... I recently changed my motherboard and had to repair install XP, then I DL'd SP2. Now when I go to device manager, my monitor and cpu are showing up twice. Anyone have any idea about this? Any help will be greatly appreciated.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Installation library for component fax could not be initialized | Porsh944t | Printing and Faxing with Windows XP | 2 | February 10th 05 08:13 PM |
| Computer Automatically Reboots When Running Scan Disk | John Maulding | Windows XP Help and Support | 3 | December 2nd 04 05:31 PM |
| Device manager problem | Alireza Amini | General XP issues or comments | 1 | October 22nd 04 07:13 AM |
| Device Manager since SP2 Install | Marcus | Windows Service Pack 2 | 1 | August 22nd 04 10:50 AM |
| Processors on Device Manager | M | Hardware and Windows XP | 1 | July 23rd 04 01:11 AM |
Linear Mode
