If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
changing language of a programe.
i have a program called pro100 which is a cabinet making program for
designing, cutting list etc. the problem is that it is in a different language. is there any way to change this to english ? thanks |
Ads |
#2
|
|||
|
|||
changing language of a programe.
Usually only when you install / setup and if there is an option to select
the language "mark" wrote in message ... i have a program called pro100 which is a cabinet making program for designing, cutting list etc. the problem is that it is in a different language. is there any way to change this to english ? thanks |
#3
|
|||
|
|||
changing language of a programe.
Usually only when you install / setup and if there is an option to select
the language "mark" wrote in message ... i have a program called pro100 which is a cabinet making program for designing, cutting list etc. the problem is that it is in a different language. is there any way to change this to english ? thanks |
#4
|
|||
|
|||
changing language of a programe.
That would be a question for their support / help desk.
"mark" wrote in message ... :i have a program called pro100 which is a cabinet making program for : designing, cutting list etc. the problem is that it is in a different : language. is there any way to change this to english ? thanks |
#5
|
|||
|
|||
changing language of a programe.
That would be a question for their support / help desk.
"mark" wrote in message ... :i have a program called pro100 which is a cabinet making program for : designing, cutting list etc. the problem is that it is in a different : language. is there any way to change this to english ? thanks |
#6
|
|||
|
|||
changing language of a programe.
"mark" wrote in message
... i have a program called pro100 which is a cabinet making program for designing, cutting list etc. the problem is that it is in a different language. is there any way to change this to english ? thanks This is not something that XP controls in any way. It's entirely dependent on what the author of the software wrote. You'll have to ask them. |
#7
|
|||
|
|||
changing language of a programe.
"mark" wrote in message
... i have a program called pro100 which is a cabinet making program for designing, cutting list etc. the problem is that it is in a different language. is there any way to change this to english ? thanks This is not something that XP controls in any way. It's entirely dependent on what the author of the software wrote. You'll have to ask them. |
Thread Tools | |
Display Modes | |
|
|