If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
After ntfs convert getting c21a stop error after a scandisk reboot
Hi, I used ghost 7.5 to put a fat32 image on a computer
and then used the convert utility to make the file system ntfs. My problem is when I perform a scandisk on the system, after it reboots, I recieve a Stop c000021a unknown hard error. If I reset the system, it works fine. At this point, this is the only time I recieve this troublesome error. I have put a second copy of winxp pro on and gave the original C: owners full security rights, but did not help. I then performed a repair and it blew out the original version and reinstalled the entire system, it coughed up when it wanted the sisage.sys file, that I could not give it since the driver is bundeled as an .exe package. Now the system is dead. I know I have to redo the system, and create the new one with the ntfs file format. Just curious if anyone else has encountered this problem and maybe has a fix. I have 100 systems that have been built on fat32 and need to be converted to ntfs, was hoping to just perform a convert as I came across them, but concerned about this stop error. Thank You for your time. |
Ads |
Thread Tools | |
Display Modes | |
|
|